heater light
heater light
noticed last night no lights on heater controls, anyone any advice on how to remove the switches to get at the bulbs, also does each conrol switch have a seperate bulb.?, thanks for any advice
-
- Joined: Fri 14 Aug, 2009 10:24
- Posts: 907
- Location: Houghton-Le-Spring
Re: heater light
Have a look in the knowledgebase there is a good guide there.
- Southernboy
- Joined: Thu 07 Oct, 2010 12:39
- Posts: 6437
- Location: Johannesburg
Re: heater light
2 bulbs only. Easiest way to approach them is to remove the headunit and reach in through the hole and down. The one light is between the blower speed control and the center aircon control..the other is between the center and left directional control.
They are closer to the top side of the control unit than the bottom, and locate into holes in the back of the control unit.
If your hands are too big to go in that way....
Remove the 2 screws on the console in the driver stairwell at top... Then get some light to light up inside the console when you bend that side panel open a little... reach in and remove the push - in bulb holders and then remove the respective bulbs.
realoem.com will give you the part numbers for OEM replacement bulbs.
They are closer to the top side of the control unit than the bottom, and locate into holes in the back of the control unit.
If your hands are too big to go in that way....
Remove the 2 screws on the console in the driver stairwell at top... Then get some light to light up inside the console when you bend that side panel open a little... reach in and remove the push - in bulb holders and then remove the respective bulbs.
realoem.com will give you the part numbers for OEM replacement bulbs.
- Southernboy
- Joined: Thu 07 Oct, 2010 12:39
- Posts: 6437
- Location: Johannesburg
Re: heater light
You may need a bandaid for a couple of small cuts from the head unit opening