Zmaxx Springs

UK forum for general and technical discussion about the Z3 roadster
Post Reply
scooobydont
Joined: Sun 22 May, 2016 08:34
Posts: 5

  Z3 roadster 2.8

Zmaxx Springs

Post by scooobydont »

Hi Folks,

I recently purchased a 2.8 Z3. It has lowering springs all round but the back still sits like its standard (too high). I have found some second hand zmaxx springs for a 1.9 Z3 that will lower it 50mm that might be worth a punt on. Can anyone advise if these rear springs will be suitable for a 2.8?

I have had a look on the zmaxx site and the 1.9 and 2.8 are different part numbers but am wondering if this is just the front springs that will be different due to the increased weight of the engine.
Post Reply