Window washer jets issue

UK forum for general and technical discussion about the Z3 roadster

Moderator: Gazza

Post Reply
HighSharpe
Joined: Sun 28 Jul, 2013 00:01
Posts: 44

  Z3 roadster 2.0

Window washer jets issue

Post by HighSharpe » Sun 12 Nov, 2017 09:26

Hello all

I have this issue with the passenger side jets not squirting water, while the driver side does.
This issue showed up in the last MOT , but the mechanic diagnosed it to a clogged pump (the driver side was weak as well) and had it replaced which made it good enough (for him) to pass.

Now the same issue shows up again and I go back to him. The little white elbow/valve inside the bonnet which connects to the black jets outside the bonnet are squirting water off the side inside the engine bay, rather than upwards.

Looking at some past posts on the forum, these need to be ordered off the dealers, but i cant seem to find any online ordering for for coopers or sopers that were mentioned in the past. Could some one point me the right way?

the part number is 61661389040 , and i might need some clamps as well (not sure what part number).

thanks
HS

User avatar
colb
Joined: Sat 05 May, 2012 23:46
Posts: 586

  Z3 roadster 1.8 TU
Location: Newport South Wales UK

Re: Window washer jets issue

Post by colb » Sun 12 Nov, 2017 10:26

Had to replace my one way valves on mine when it started spraying under the bonnet into the engine bay behind the sound deadening lining. Obtained mine from BMW dealer about £9 per pair.
http://www.realoem.com/bmw/enUS/showpar ... Id=61_0171
Quite why they do this is a mystery but I suspect a rubber flap inside gets hard and lets the water out of a drain hole on the underside of the valve. They just push in to the tubing no clips involved, at least mine didn't have any fitted. Blow through the actual jets in the bonnet or probe them with a needle to make sure they are clear.
Good idea to take the reservoir bottle out and give it a good clean out, often gets a jelly like substance build up inside over the years which causes flow problems.
Colb
1999 BMW 1.8 Z3
1998 Honda Deauville NT650V

HighSharpe
Joined: Sun 28 Jul, 2013 00:01
Posts: 44

  Z3 roadster 2.0

Re: Window washer jets issue

Post by HighSharpe » Sun 12 Nov, 2017 14:05

thanks colb for the info.

If i may ask - how did you order them? Is there a website or phone number?

thanks.

1963paul
Joined: Sat 19 Jul, 2014 14:19
Posts: 89

  Z3 roadster 2.0

Re: Window washer jets issue

Post by 1963paul » Sun 12 Nov, 2017 15:12

I had same problem, just removed the white valves altogether, only difference is it takes a fraction longer for the water to come out.

andy & fonz
Joined: Tue 28 Jul, 2015 18:35
Posts: 47

  Z3 roadster 2.2i

Re: Window washer jets issue

Post by andy & fonz » Sun 12 Nov, 2017 15:29

took mine off as well, have encountered no problems, if you do this you will need a short piece off pipe for the drivers side, in fact they work better without the valves

User avatar
colb
Joined: Sat 05 May, 2012 23:46
Posts: 586

  Z3 roadster 1.8 TU
Location: Newport South Wales UK

Re: Window washer jets issue

Post by colb » Sun 12 Nov, 2017 17:10

If you want replacements call in or phone your local BMW dealer quote the part number and normally they will be available next day for picking up. They will take a payment over the phone usually.
Colb
1999 BMW 1.8 Z3
1998 Honda Deauville NT650V

User avatar
g8jka
Z Register member
Joined: Sun 18 Apr, 2010 22:16
Posts: 1147

  Z3 roadster 2.8
Location: Telford

Re: Window washer jets issue

Post by g8jka » Sun 12 Nov, 2017 21:13

£9.36 for the pair, ordered a couple from Sopers about 2 weeks ago. Pay over the phone and they will post out to you.
2000 BMW Z3 2.8 Titanium Silver Roadster with too many mods to list :-D :drive
Image
Click For 2.0 Progress Journal
Click For 2.8 Progress Journal

Post Reply

Who is online

Users browsing this forum: Bing [Bot] and 3 guests