HELP! Seat Not Working

Andrew330Ci · Post by **Andrew330Ci** » Thu 19 Jun, 2008 22:18

Hi everyone need your help!

I have got the seat bushes from Whalen needed to be done.

Started in the passenger seat out, changed all the bushes, got the aligning pin and bolts up all ok. The rails on each side match up ok and can be secured into the bolts in the car

BUT

The seat doesnt move forward or back, electrically obviously has anyone experienced this when changing the bushes?

Thanks

Andrew

DougW. · Post by **DougW.** » Sat 21 Jun, 2008 01:12

Did you sand the bushes down until you could shove them into place with thumb pressure?

I've heard of folks leaving them too thick and hammering them into position; evidently, the adjustment nut needs to float inside it's housing, or it may keep the motor from turning.

Dax · Post by **Dax** » Sat 21 Jun, 2008 10:48

This guy demonstrates the replacement of the bushes from start to finish quite well... maybe an answer in there somewhere???

Part 1 - http://www.youtube.com/watch?v=DM4KSnA58EI
Part 2 - http://www.youtube.com/watch?v=GRxrPelM ... re=related
Part 3 - http://www.youtube.com/watch?v=7fdDHzyk ... re=related

Andrew330Ci · Post by **Andrew330Ci** » Sat 28 Jun, 2008 21:56

Just thought I'd give you an update after an entire day doing this!

It is complete, reason is it still needs to have some movement between the bushes, so just need to make sure when replacing it does need just push in with fingers no more.

Hope that helps people for the future!

BIG IMPROVEMENT! No movements what so ever its brilliant!